Edelbrock AVS2 500 CFM Carburetor w/Electric Choke Satin Finish (Non-EGR)

Description

Edelbrock AVS2 500 CFM Carburetor w/Electric Choke Satin Finish (Non-EGR)

Edelbrock #1901 AV2 Series 500 cfm Carburetor

The Edelbrock #1901 AV2 Series 500 cfm Carburetor is designed and calibrated for small cubic-inch single carb applications, matching with an Edelbrock Performer or Performer EPS manifold or other brands of similar design.

Includes both timed and full vacuum ports for ignition advance. #1901 is calibrated for single-quad applications and factory equipped with: Metering Jets – Primary .095, Secondary .095, Primary Rod .070 x .052, orange spring (5′ Hg). Use carb Studs #8008 or #8024 if needed. Match with an Edelbrock intake manifold for the ultimate induction upgrade.

How to use instructions

Fitment

Edelbrock’s Warranty

For information on Edelbrock’s warranty terms and conditions, please click here.

Purchase Disclaimer: You are hereby informed and warned to check your local, state, and federal laws before buying and installing these or any aftermarket parts to be sure whether usage is in violation. All installation-risk and use-risk is borne by the end-user and installer of these parts. Bolt Motorsports does not condone the use of emission defeat devices for any vehicles used on public streets or roadways. Bolt Motorsports will not tamper, remove, disable, or bypass emissions equipment on a motor vehicle in accordance with 40 CFR Section 86.1854.12(a)(3), Clean Air Act 40 CFR 1068.101(b). This includes software, known as tunes, that reprogram a motor vehicles electronic control module to alter engine performance and enable the removal of filters, catalysts, and other critical emissions controls. In accordance with local laws and regulations, Bolt Motorsports will not ship parts to locations where usage or installation of said part would be in violation of the aforementioned acts.