Snow Performance Gas Stage I The New Boost Cooler Forced Induction Water Injection Kit

Description

Snow Performance Gas Stage I The New Boost Cooler Forced Induction Water Injection Kit

Race Gas Quality Fuel on Pump Gas

Increase your pump gas octane by 25 points and make more power efficiently with a cooler running motor! The Snow Performance Stage 1 Boost Cooler water-methanol injection kit is available for all forced induction applications (Supercharged/Turbocharged) and uses an adjustable boost switch to inject a fixed amount of water methanol into the system until boost goes below the switch set point. Proven to deliver 30-70 HP increases to all forced induction applications! This makes it a good choice for low to medium boost setups, drag race applications, and vehicles with a positive displacement supercharger (Roots/Twinscrew) looking for an octane enhancement and cooler intake charge. Activation can also be set up through any other user chosen switch, such as a full throttle switch, nitrous switch, etc.

Premium Construction

This kit utilizes the only OEM-approved water-methanol injection pump on the market with proprietary heat flange, twin seals, and custom motor winding to run cooler and longer than the competition. The Extreme Environment 300 PSI UHO Pump is designed to be in the elements with O-Ring connections that are then sealed and potted to ensure no moisture can enter the pump internals. Compare this to pumps that use a pump “sleeve”. These sleeves will keep moisture around the pump unit leading to corrosion as well as trap heat to greatly decrease pump life. The Stage 1 comes standard with 100% methanol resistant components using stainless steel, nickel plating, EPDM, and hard anodizing to ensure years of continued use. Tie that in with new Snow Performance ACU-SEAL compression fittings for guaranteed leak-free operation even when using 100% methanol. For an extremely robust, reliable water-methanol injection experience that won’t break the bank look no further than the Snow Performance Stage 1 Boost Cooler!

Features

• U.S.A. Made
• Adjustable Water Methanol Engagement & Monitoring
• Recommended For High HP, Drag Race, and Positive Displacement Supercharger Applications
• Supports 1,000+ HP
• 100% Methanol Resistant (Stainless Steel, Nickel Plating, Hard Anodizing, EPDM)
• Snow Performance Hyper-Sonic Water Methanol Nozzle
• Snow Performance ACU-SEAL Water Methanol Compression Fittings
• Snow Performance OEM Approved Extreme Environment 300 PSI UHO Water Methanol Pump
• Snow Performance Running “S” Engraved Low Profile Nozzle Holder
• Snow Performance Running “S” Engraved Low Profile High Flow Check Valve

Snow Performance Warranty

For information on Snow Performance’s warranty terms and conditions, please click here.

Purchase Disclaimer: You are hereby informed and warned to check your local, state, and federal laws before buying and installing these or any aftermarket parts to be sure whether usage is in violation. All installation-risk and use-risk is borne by the end-user and installer of these parts. Bolt Motorsports does not condone the use of emission defeat devices for any vehicles used on public streets or roadways. Bolt Motorsports will not tamper, remove, disable, or bypass emissions equipment on a motor vehicle in accordance with 40 CFR Section 86.1854.12(a)(3), Clean Air Act 40 CFR 1068.101(b). This includes software, known as tunes, that reprogram a motor vehicles electronic control module to alter engine performance and enable the removal of filters, catalysts, and other critical emissions controls. In accordance with local laws and regulations, Bolt Motorsports will not ship parts to locations where usage or installation of said part would be in violation of the aforementioned acts.